HEATIT is registered Trademark by zhukeshi(We didn't authorize other sellers in Amazon.com). Suitable for use on rigid plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Protect pipes up to 1.5" in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather.
Industrial grade self regulating heating cable. The cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.
Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. Easy to install and use. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient.
ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10¡æ. The minimum bending radius is 1 inch.Tough XLPE as inner insulation and weather resistant P (high-low temperature) as out jacket. Ingress Protection 65. Approved for water filled rigid plastic pipe and metal pipe. Durable
Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Two year limited warranty - If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we'll try our best to solve your issue